Fits standard, square based 600 ml tetra pack milk cartons
5 mm neoprene
Base: (inside diameter) 70 mm, (-/+ 3% variability) ‘checker plate’ raw neoprene (helps the cooler grip to table tops). Fixed in place with a 2 part neoprene adhesive
Wall height: 115 mm, (-/+ 3% variability) covered both sides with jersey (see colour chart links below).
Seams: firstly glued together with 2 part neoprene adhesive, then zigzag stitching full length of the seam, then tacked top and bottom. Also available with black Mauser tape, sewn on with a running stitch (not required for extra strength — only for visual impact).
Blank size (before forming into a square based tube) 285 x 115mm (-/+ 3 % variability)
Printing Techniques Available
Single colour Screen Print
Minimum print run 50.
38 Neoprene colors available (see colour chart) and these can be mixed within the order, in minimum multiples of 10.
Plenty of room, for a three sided ‘front and 2 sides’ print. I suggest three 70 x 95mm art blocks, with a 10mm gap between. 70mm is the visible width of a cooler ‘face’ — so no need to rotate the cooler to read a message/logo if kept to this size.
Plenty of room, for a three sided ‘front and 2 sides’ print. I suggest three 70 x 95mm art blocks, with a 10mm gap between. 70mm is the visible width of a cooler ‘face’ — so no need to rotate the cooler to read a message/logo if kept to this size.
Pricing is affected (slightly) by artwork area, and amount of colors printed, so please attach preliminary art to the quote page, or describe in the comments box. Art areas available are 100 x 90 mm, 190 x 45 mm, 145 x 65 mm, 190 x 55 mm, 190 x 70 mm, 100 x 140 mm, 190 x 90 mm.
You are not limited to picking your Neoprene colour from the colour chart. The background colour (which becomes the cooler colour) is printed at the same time as your unlimited colour art, over the top of white neoprene blanks (inside colour black). Once printed, none of the white is left showing.
We are unable to mix the background colors, within an order — each would be a new print run (minimum 24).
Art size maximum 265 x 95mm (if supplying artwork, your background colour needs to be 295 x 125 mm, which fully covers the 285 x 115 mm blanks, with some ‘bleed off’).
Plenty of room, for a three sided ‘front and 2 sides’ print. I suggest three 70 x 95mm art blocks, with a 10mm gap between. 70mm is the visible width of a cooler ‘face’ — so no need to rotate the cooler to read a message/logo if kept to this size.
